GPS Receiver SPK-LT548SLP (Sirf star III Single Chip GPS Receiver module )
| Welcome ! This category contains detailed information for GPS Receiver SPK-LT548SLP (Sirf star III Single Chip GPS Receiver module ) products. New GPS Receiver SPK-LT548SLP (Sirf star III Single Chip GPS Receiver module ) products will be constantly updated in and added into this category. |
| |
GPS Receiver SPK-LT548SLP ( Sirf star III GPS Receiver module (24mm*20mm*2.6mm) ) |
Specifications
Technical Specifications
Feature Item Description
Chipset GSC3f SiRFstarIII low power single chipset
General
Frequency L1, 1575.42 MHz
C/A code 1.023 MHz chip rate
Channels 20
Accuracy
Position
10 meters, 2D RMS
5 meters 2D RMS, WAAS corrected
<5meters(50%)
Datum
Time to First Fix
(TTFF) (Open Sky & Stationary
Velocity 0.1 meters/second
Time 1 microsecond synchronized to GPS time
Default WGS-84
Other selectable for other Datum
Reacquisition 0.1 sec., average
Snap start 1 sec., average
Hot start 1 sec., average typical TTFF Warm start 38 sec., average typical TTFF
Requirements) Cold start 42 sec., average typical TTFF
Dynamic
Conditions
Power
Serial Port
Time-1PPS Pulse
Altitude 18,000 meters (60,000 feet) max.
Velocity 515 meters/second (1000 knots) max.
Acceleration 4g, max.
Jerk 20 meters/second3, max. Main power input 3.3 ~ 5.0 VDC input
Power consumption ≈165 mW (continuous mode) Supply Current ≈49 mA
Backup Power 1.65 ~ 5.0 VDC input.
Electrical interface Two full duplex serial TTL interface.
Protocol messages NMEA-0183@4800 bps (Default) Level TTL
Pulse duration The 1PPS pulse width is 1 µs, this 1PPS is NOT suited to steer various oscillators (timing receivers, telecommunications system, etc).
Time reference At the pulse positive edge.
Measurement Aligned to GPS second, 1 microsecond
Environmental Characteristics
Items Description
Operating temperature range -40 deg. C to +85 deg. C
Storage temperature range -55 deg. C to +100 deg. C
Physical Characteristics
Items Description
Length 24 mm ± 0.1mm (0.94in)
Width 20 mm ± 0.1mm (0.79 in) Height 2.9 mm ± 0.1mm (0.11 in)
Weight 2.5g
Interface Specifications
Items Description
I/O 28 pin SMD micro package
|
|
| |
SPK-GPS-GS405 SMART ANTENNA (SIRF STARIII) ( GPS Receiver module+ Sarantel Geohelix SMP-Passive Antenna ) |
1.2. MAIN FEATURES
Built-in SiRF Star III chipset with standard SiRF GSW 3.0 software
Built-in Sarantel omni-directional Geo-helix SMP passive antenna, increases GSP
signal reception sensitivity
Twenty parallel satellites tracking channels for fast acquisition.
A-GPS ready
Compact size
Support NMEA0183 V. 3.01 data protocol.
TTL level output serial port easily for system on board integration
1.3. KEY BENEFITS
Integrate GPS antenna and receiver
Filtering effect of the antenna gives high immunity to RF interface
High sensitivity GPS solution – Fast TTFF
Wide antenna Beam width
Simple integration and acceleration for time-to-market
2. SPECIFICATION
2.1. ABSOLUTE MAXIMUM RATING
Parameter
Min
Typ
Max
Units
Power Supply Voltage
3.1
3.3
3.5
V
Operating Current
67
75
82
mA
2.2. GEOHELIX-SMP GPS ANTENNA CHARACTERISTICS
Parameter Min Typ Max Unit
Frequency 1573.42 1575.42 1577.42 MHz
Gain -5.5 -3.5 dBic
Beamwidth >120 Degrees
VSWR 2.0:1 2.3:1
Impedance 50 Ω
Operating Temperature Range -40 +20 +85 ℃
2.3. GPS TECHNICAL SPECIFICATION
ITEMS DESCRIPTION
Chipset GRF3w&GSP3f SiRF StarIII technology
General Frequency L1, 1575.42 MHz
C/A code 1.023 MHz chip rate
Channels 20
Accuracy Position 10 meters, 2D RMS
5 meters 2D RMS, WAAS enabled
< 5meters(50%), DGPS corrected
Velocity 0.1 meters/second
Time 1 microsecond synchronized to GPS time
Datum Default WGS-84
Other selectable for other Datum
Time to First Fix (Open Sky & Stationary Requirements) Reacquisition 0.1 sec., average
Snap start 1 sec., average
Hot start 8 sec., average
Warm start 38 sec., average
Cold start 42 sec., average
Dynamic
Conditions Altitude 18,000 meters (60,000 feet) max.
Velocity 515 meters/second (1000 knots) max.
Acceleration Less than 4g
Jerk 20 meters/second3, max.
Power Main power input 3.3 ± 5%V DC input.
Power consumption Less than 250 mW (Continuous mode)
Supply Current ≈75 mA (Continuous mode)
Backup Power See section 2.9 PIN DESCRIPTION Pin#7
Serial Port Electrical interface One full duplex serial TTL UART interface.
Protocol messages NMEA-0183@4800 bps (Default)
Timemark-1PPS Pulse(Customization
Device) Level TTL
Pulse duration 100ms
Time reference At the pulse positive edge.
Measurements Aligned to GPS second, 1 microsecond
2.4. EXTERNAL BACKUP POWER CONDITIONS
PARAMETER Symbol Min Typ Max Units
RTC(Battery) Power BATTERY 2.0 5.0 V
Supply Current 15 µA
2.5. SOFTWARE OPERATION CONDITION
ITEMS DESCRIPTION
Core of firmware SiRF GSW version 3.0
Baud rate 4800 (Default)
Code type NMEA-0183 ASCII
Datum WGS-84
Protocol message GGA, GSA, GSV, RMC / per second.
Output frequency 1 Hz
Acquisition Sensitivity Cold start 28 dB-Hz (-143dBm)
Warm start 28 dB-Hz
Hot start (Standard) 15 dB-Hz
Tracking -159 dB
2.6. COMMUNICATION SPECIFICATION
PARAMETER SPECIFICATION
Interface Simple UART
Bit rate 4,800 bps
Start bit 1 bit
Stop bit 1 bit
Data bit 8 bit
Parity None
Transmission data NMEA 0183 Ver3.01
2.7. ENVIRONMENTAL CHARACTERISTICS
ITEM MINIMUN MAXIMUM
Operation conditions -40℃ +85℃
Storage conditions -55℃ +100℃
* Operation humidity: 5 % to 90 % No condensing.
2.8. OTHER CHARACTERISTICS
ITEMS DESCRIPTION
Physical
Characteristics Length (with Antenna) 52mm (2in)
Width 25.6mm (1in)
Weight ≈16g
|
|
|